As an important auxiliary material in the aluminum wire drawing and aluminum alloy drawing process - aluminum wire drawing oil, its quality will directly affect the quality of the aluminum wire drawing finished product and the finished line.

Many small and medium-sized enterprises, greedy for cheap purchase of non-standard aluminum brushed oil, which looks cheap on the surface, but is more expensive in actual use! The following issues are usually faced.

1. Short service life

In the process of using drawing oil, poor quality drawing oil due to more sludge, more yellow robe, poor sedimentation performance, then the oil film taken away by the aluminum wire is thicker when stretching, which will lead to large daily maintenance consumption. The normal use cycle of aluminum wire drawing oil is 6-10 months, and the use cycle of low-end products is only 3-4 months.

2. The mold loss is fast

The lubricity of the oil is not enough, resulting in mold wear. Stable lubrication effect, high oil film strength, not only can make the surface of the wire high brightness, no tensile marks, but also have a good protective effect on the mold, avoid mold wear; At the same time, it fully meets the high lubrication requirements of aluminum stretching, so that the finished product line has a good surface condition; Reduce friction and reduce electrical energy consumption for wire drawing.

3. High loss of raw materials

The excellent sedimentation of the drawing fluid can ensure the rapid settlement of aluminum powder in the drawing oil pool, maintain the cleaning and easy cleaning of the drawing fluid system to eliminate pollutants, so as to avoid the adverse impact of aluminum powder on product quality; And it is convenient for the secondary recycling of drawing fluid.

Aluminum drawing oil adopts the national standard I and II basic oil blending, although the cost is a little higher than the non-standard drawing oil, but because of less sludge, less yellow robe, so its aluminum powder settlement performance, not only long use time, tower wheel, mold has a good protective effect, reduce loss. The comprehensive calculation of the unit cost can be reduced by 20-40%, reducing costs and increasing efficiency for customers.